Operation manual and precautions for the use and maintenance of flip garage doors
p>
1. Daily operation: The user only needs to click the remote control to open and close the door. When the door is moving, click any key on the remote control to stop the door.
2. If there is a power outage when closing the door, you can pull the clutch to close the door manually. The door body has a self-locking function. When you need to open the door next time, make sure that the door opener has power, press the close button first, and wait for the chain After the connector and slider are combined (up to 40 seconds), press the door opening button again to open the door normally.
1) If there is still no power, you cannot open the door remotely and can only use the key to open the door.
2) During a power outage, when pulling out the clutch to manually open and close the door, push it slowly.
3. Observe the power indicator light: Open the case and the power indicator light (POWER) flashes when the power is turned on.
4. The remote control distance is greatly affected by the weather. It is normal for the remote control distance to be shortened under severe weather conditions. When the remote control distance is significantly shortened, the remote control battery should be replaced. The model is DC12V/23A. Note that the battery cannot If installed backwards, the remote control must not get wet, dropped, or knocked!
5. A 10W/24 VAC bulb is installed in the door opener when it leaves the factory. If the bulb burns out, the user can purchase a replacement by himself. . Please unplug the power plug before replacement.
6. When the remote control distance is ≤5 meters, the user can change to another remote control handle and try again. If both remote control handles cannot control the door normally, the user can contact the dealer or our company .
7. Regularly check the balance of the torsion spring of the door body. The door body should be easily pushed up and down by hand when the clutch is disengaged.
8. Users who have chosen the infrared protection function should frequently test the infrared protection system to ensure its normal function.
本站内容及图片来自网络,版权归原作者所有,内容仅供读者参考,不承担相关法律责任,如有侵犯请联系我们:609448834